What to do right now
- Remove standing water first. Drying equipment can't keep up while water still sits on the floor or under the house.
- Run the air conditioning. Closed windows and AC on cool help, because outdoor air in this climate is often too humid to dry anything.
- Pull wet rugs and soft items out. Move them to a dry space or outside on a sunny day.
- Don't seal it up. Hold off on new paint, flooring or drywall until a meter says the structure is dry.
- Note when the water arrived. The EPA's 24-to-48-hour window for drying starts then, and the provider will ask.
Why local houses dry differently
Raised pier-and-beam houses. Older New Orleans houses, including many shotguns and Creole cottages, were built on raised piers so water could pass underneath, as the state's history of building elevation and the city's historic district storm guidance describe. When water stays below the floor, the job is drying the crawl area, the sills and the underside of the floor. When it rises above the floor, water gets into the subfloor, the wall bottoms and often old plaster, and air has to reach both sides of the floor.
Slab-on-grade houses. Much mid-century and suburban construction across the metro sits on concrete slabs. Concrete takes on water slowly and releases it slowly, and flooring glued or nailed to it traps moisture. Wet slab drying often needs flooring removed and dehumidification for longer than the walls need.
Elevated rebuilds. Many homes raised after Katrina sit on tall piers with parking or storage below. Water in the space below the lowest floor is a different drying job, and it also matters for insurance; see the flood insurance gap checker.
Drying classes, briefly
| Class | What it means | Typical local case |
|---|---|---|
| 1 | Small wet area, little absorbed water | A spill caught quickly on tile |
| 2 | A whole room, carpet and lower walls wet | A water heater leak into a bedroom |
| 3 | Ceilings, walls, insulation and floors soaked | A roof opened in a storm, rain from above |
| 4 | Water held deep in dense materials | Hardwood, plaster on lath, a wet slab |
The classes come from the IICRC S500 standard and help a provider size equipment. Class 4 jobs take the longest.
What a drying plan includes
- A moisture map of floors, walls and ceilings, marked on a sketch
- Dry standards: readings from unaffected materials of the same type
- Equipment list: air movers, dehumidifiers, sometimes heat or specialty mats for hardwood
- Daily readings in the same spots, so you can see progress
- A clear finish line: readings at or near the dry standard, recorded before rebuild
Planning costs
On the pricing page, extraction and drying is listed per square foot by water category: $4–$6 for clean water, $6–$9 for gray water and $9–$12 for contaminated water. Whole-job bands run $1,500–$5,000 for a typical job and $5,000–$15,000 for a major one, before rebuild.
Records for your claim
- The drying log with dates, locations and readings
- Equipment counts and the days each piece ran
- Photos of meters on the wall or floor with the reading visible
- Any material removed and the reason it could not be dried
General information only; your policy and insurer decide coverage.
When you might do it yourself
A small, clean spill on a hard floor caught within hours can often be handled with fans and the AC. Bring in a provider when water reached walls, a slab under flooring, a raised floor system or plaster, or when you can't get readings yourself.
Related tool
The raised house vs slab drying planner asks about your foundation, water height and water type, then explains the likely drying class and the order of work.