What to do right now
- Go back only when it is safe. Wait for officials to reopen your area after a storm, and never wade or drive through moving water. Shallow water can hide open drains, downed lines and missing manhole covers.
- Keep the electricity off. If water reached outlets, appliances or the breaker panel, leave the main off and have an electrician check it. If you smell gas, leave and call the gas utility from outside.
- Photograph before you clean. Shoot the high-water line on every wall, inside and out, then each damaged item before it goes to the curb. Measure the line with a tape and include the tape in the photo.
- Dress for contaminated water. Rubber boots, gloves and an N95 mask at minimum. Treat anything the floodwater touched as dirty until it is cleaned or thrown out.
- Report the loss to your flood insurer. Flood is normally a separate NFIP or private flood policy, not your homeowners policy. Ask for the claim number and write it down.
Why floods behave differently here
- The city is a set of bowls. The National Weather Service paper on the August 5, 2017 flood describes New Orleans as a group of polders with no downhill outlet. Rain that falls inside them has to be pumped out through canals to Lake Pontchartrain.
- Pumps have a design rate. The same paper gives the Sewerage & Water Board's stated capacity as 1.0 inch in the first hour and 0.5 inch each hour after. In 2017 parts of Mid-City got more than 9 inches in three to six hours.
- The ground keeps sinking. USGS researchers reported average subsidence of about 5 mm a year in the leveed metro area between 1951 and 1995, with some neighborhoods already 1.5 to 3 meters below sea level.
- Surge is the big one. The National Hurricane Center's Katrina report says about 80% of the city flooded in 2005, with depths up to about 20 feet, after levees and floodwalls were overtopped or breached.
Why outside water counts as contaminated
The IICRC S500 standard sorts water by how dirty it is. Category 1 is clean water, such as a supply line. Category 2 carries some contamination, like a washing machine drain. Category 3 is grossly contaminated: sewage, and floodwater that rises from rivers, canals, lakes or streets. Floodwater from outside is treated as Category 3 from the start, which is why porous materials it soaks are usually removed rather than dried in place.
Drying effort is grouped into four classes in the same standard, from Class 1 (a small wet area of mostly low-absorbency material) to Class 4 (water held deep in dense materials such as hardwood, plaster or a concrete slab). Most whole-house floods land in the upper classes.
What a provider typically does
| Stage | What happens | Why it matters |
|---|---|---|
| Assessment | Safety check, photos, moisture map, water category and drying class | Sets the scope your insurer will review |
| Water removal | Pumps and extraction units pull standing water and silt | Every gallon left behind adds days of drying |
| Tear-out | Wet carpet, pad, baseboards and drywall above the waterline come out | Category 3 water ruins porous materials |
| Cleaning | Mud-out, scrubbing and an antimicrobial on remaining framing | Removes the contamination the water carried |
| Drying | Air movers and dehumidifiers, with daily readings | Proves the structure is dry before rebuild |
| Records | Readings, photos and an itemized scope for your claim | Supports the adjuster's review |
How long it takes
There is no honest single number. Water removal and tear-out move quickly once a crew is on site; drying lasts until the moisture readings match dry reference readings, which takes longer for slabs, plaster, hardwood and old heart-pine framing than for new studs. Rebuild starts only after the readings show the structure is dry, and it is usually quoted separately.
What it costs
The planning ranges on this site come from published national cost guides and are listed on the pricing page:
| Job size | What it looks like here | Planning range |
|---|---|---|
| Typical | Two rooms of a slab house took a few inches of street water | $1,500–$5,000 |
| Major | Several rooms with wet drywall, cabinets and subfloor, or sewage mixed in | $5,000–$15,000 |
| Disaster-scale | Surge or deep water through the whole house | $15,000+ |
Contaminated water is priced at $9–$12 per square foot for extraction and drying in the same guides, higher than clean water. Rebuild, contents cleaning and mold work are extra.
Claim documentation checklist
- Date and time the water entered, and when it went down
- Photos and video of the waterline on each wall, with a tape measure in frame
- A list of damaged items with age and rough value, photographed before disposal
- The provider's daily moisture readings and drying log
- An itemized scope that separates cleanup, drying and rebuild
- Receipts for anything you paid out of pocket, including hotel stays
- Your flood policy number and, if you have one, the Elevation Certificate
Your insurer and policy decide coverage. This is general information, not insurance advice.
When to call and when you can wait
Call for help when water came from outside, sat for more than a day, reached the walls, came with sewage, or got into a raised floor system. A shallow puddle of clean rainwater on tile that you can dry in a few hours is a job you may handle yourself, if you keep an eye on baseboards and grout for the next week.
Free tools for flood cleanup
- Street flood or indoor leak? sorts out the water category and which policy is likely involved.
- Raised house vs slab drying planner explains how your foundation changes the drying plan.
- NFIP ICC coverage checker explains the extra flood-policy money for elevation after substantial damage.
- Flood insurance gap checker lists what a flood policy may leave uncovered.